Numerical and Experimental Investigation of H2-Air and H2-O2 Detonation Parameters in a 9 m Long Tube, Introduction of a New Detonation Model

Experimental and numerical investigation of hydrogen-air and hydrogen-oxygen detonation parameters was performed. A new detonation model was introduced and validated against the experimental data. Experimental set-up consisted of 9 m long tube with 0.17 m in diameter, where pressure was measured with piezoelectric transducers located along the channel. Numerical simulations were performed within OpenFoam code based on progress variable equation where the detonative source term accounts for autoignition effects. Autoignition delay times were computed at a simulation run-time with the use of a multivariate regression model, where independent variables were: pressure, temperature and fuel concentration. The dependent variable was the autoignition delay time. Range of the analyzed gaseous mixturecomposition varied between 20% and 50% of hydrogen-air and 50%–66% of hydrogen in oxygen. Simulations were performed using LES one-equation eddy viscosity turbulencemodel in 2D and 3D. Calculations were validated against experimental data