The HSP discourages the use of this type of piping for hydrogen despite the low likelihood of ignition within the pipe itself. The polyethylene film can indeed develop a charge and, depending on the film thickness and substrate wall material, will eventually produce an electrostatic discharge. Since the nominal hydrogen concentration is so high (and assuming the purge-in and purge-out…

Precautions applicable to oxy-acetylene torches are likely applicable here and are a good starting point. Recommendations for the hardware are best provided by the cylinder supplier, and all these parts can be purchased from their respective catalog. All three devices in the question should have UL listings, FM approvals, or some other nationally recognized testing laboratory (NRTL) listing,…

The information provided is not only outdated in terminology, but also misleading in quantifying the dispersion of hydrogen in terms of comparison of diffusion of air in air. Hydrogen diffuses 4X faster than air, and the rate of mixing has many variables, so there isn’t just one answer. However, it’s generically safe to say that an initial hydrogen gas cloud outdoors and unconfined will…

There is no generalized exception for hydrogen fueling stations.  However, PSM is intended for employee protection. It’s not intended for retail operations or customers. Through paragraph 1910.119 (a)(2)(1) of the regulation, PSM exempts retail facilities. Some may use this exemption as a means to exclude H2 retail fuel sites from PSM.

Fuel stations that are non-retail, such as…

The cleanliness of an H2 piping system is often based on end use requirements since the purity of the system may impact the end use application. Cleanliness required for end use purity is usually much greater than that required to prevent condensation or oxygen content sufficient to create a safety risk. While not required for the same safety reasons as oxygen safety, specifying a system to be…

Yes, the pressure safety relief system on LH2 tanks is sized for the loss of vacuum condition. The spring-loaded safety valves are sized for lower demand cases such as runaway pressure build or loss of vacuum. Higher demand requirements, such as loss of vacuum combined with fire, are handled by the rupture discs and are sized for such an event.

Off gassing of hydrogen from battery sources depends on battery chemistry, usage/duty cycle, age, and other considerations. The specific battery manufacturer should provide recommendations for fire prevention and mitigation in battery charging rooms as the battery itself impacts how an event would be mitigated. Adequate ventilation such that combustible mixtures cannot develop is a general…

Because hydrogen is labeled as a hazardous substance, sometimes people are concerned about the environmental impact of releasing liquid hydrogen. There are currently no regulations that require reporting of hydrogen releases for environmental reasons.

However, there are safety implications. For example, the US DOT requires reporting of hazardous materials releases under certain…

It is not possible to define ignition potential by just velocity without more data (i.e. pressure, materials involved, direction of impact). Due to the multiple methods of developing an ignition source (friction, impact, electrical charge) and the low ignition energy, it is assumed that hydrogen in the air will ignite (between 4 -74%), as it does 30-40% of the time with no known ignition…

Purging can be accomplished in several ways including by using pressure cycles, sweeping, or vacuum. Sweeping is the least reliable but can be effective on simple pipe runs. In most cases, vent systems are open to the atmosphere and the ingress of air from the outlet is likely. However, the vent system should be designed to handle fire or explosion internally. This
generally is not…