There are several concerns with “snuffing” a hydrogen fire from a vent stack. Most importantly, snuffing a hydrogen fire before the hydrogen is isolated can lead to the buildup of a hydrogen vapor cloud, which may then re-ignite, especially with hot surfaces available from the previous fire. The largest hazard is an explosion of the vapor cloud caused by delayed ignition.  It’s always better to isolate the hydrogen at its source to extinguish the fire as fuel runs out. 

Snuffing systems have been used in the past for vent system outlets mainly due to the negative   perception of a visible hydrogen flame at the top of the vent stack, particularly at night.  The success of these systems was marginal since high and sustained rates of inert gas were required to snuff the flame and sufficiently cool the piping outlet to prevent the venting flow from reigniting.  Generally, it’s preferred to design the vent system such that it can withstand a worst-case continuous fire on the outlet without affecting its integrity or surrounding exposures.  If those criteria are met, then it’s inherently safer to allow the vent to burn than to try to snuff it. 

Situations where extinguishing a hydrogen leak prior to stopping flow is safer are rare. Hydrogen releases have a high potential for inadvertent re-ignition and subsequent explosion. Some vent stacks might be equipped with an extinguishing system, but these often can be more hazardous than allowing a properly designed vent stack to continue to burn until the source is isolated.